When re-opening the Warp Transformation, the Constrain Control Points selection is not preserved
Posted: December 30th, 2024, 7:27 pm
When re-opening the Warp Transformation, the Constrain Control Points selection is not preserved
To reproduce the problem:
1. Start PWP 8.0.474
2. Create a Color Chart Test Pattern
3. Create a Warp Transformation and select the "Only move control points vertically" button
4. Click on OK to close the Warp Transformation
5. Re-open the Warp Transformation
6. Note that Constrain Control Points selection has not been preserved
Jeff
To reproduce the problem:
1. Start PWP 8.0.474
2. Create a Color Chart Test Pattern
3. Create a Warp Transformation and select the "Only move control points vertically" button
4. Click on OK to close the Warp Transformation
5. Re-open the Warp Transformation
6. Note that Constrain Control Points selection has not been preserved
Jeff