Illegal Angle Value message after resetting Level transformation

[davidh]

1. open Level transformation
2. click Align To Vertical button to position the Line Overlay vertically
3. go to Settings, click Reset and right away click again Align To Vertical button -> you (might) get an error message Illegal Angle Value

However, if you wait a bit before clicking again Align To Vertical button, the Line Overlay blinks once as it refreshes and after you click Align To Vertical button again, there in no error message.

I believe that on fast computers the Line Overlay refreshes instantly with the Reset command, so there is no chance for the error message.
On my computer the delay is about 2 seconds.

[jsachs]

I can't reproduce this here, but I did rewrite the code for the next release to eliminate the unnecessary delay which hopefully will fix it for you.

[davidh]

You will have a fast computer :).
Thanks.